To Next PageTo Next Page
Need help?Do you have a question about the Partner P180107H and is the answer not in the manual?
General| Weight | 30 kg |
|---|---|
| Cutting Width | 46 cm |
| Displacement | 125cc |
| Engine Type | 4-cycle |
| Engine Displacement | 125cc |
Read instructions, be familiar with controls and proper use of the equipment.
Inspect for debris, wear proper footwear, clear the area before use.
Do not operate in confined spaces, mow in daylight, disengage blades before starting.
Disengage PTO, lower attachments, set parking brake, stop engine, remove key.
Keep nuts tight, store away from ignition sources, cool engine before storing.
Mount steering wheel, align front wheels, and secure with bolt and washer.
Remove hardware, discard packing, position seat, engage pads, pull seat back, tighten bolt.
Lift adjustment lever, slide seat for comfort, release lever to lock.
Remove metal jewelry, connect positive terminal first, then negative, grease poles.
Identify and understand the function of each control on the machine.
Use unleaded petrol, do not overfill, secure cap, store properly.
Check engine oil level using the dipstick, ensure proper inflation of tires.
Check tire pressure regularly and maintain correct inflation.
Ensure cutting unit is in transport position, engage parking brake, press clutch/brake pedal.
Warm up transmission for 1 minute in neutral before driving.
Procedure to remove trapped air from transmission before operation or after service.
Lower cutting unit, choose speed according to terrain, release brake/clutch pedal slowly.
Ensure systems work properly, warnings about backing up with attachment engaged.
Clear lawn of objects, avoid wet grass, mow often, clean cutting unit after use.
Do not drive on slopes over 15°, avoid stopping/starting on slopes, drive perpendicular.
Use right turns to throw grass away, use left side for cutting close to obstacles.
Disengage clutch, set throttle, lift cutting unit, turn key to STOP.
Disconnect spark plug wire, press brake pedal, set parking brake, move control lever to neutral, disengage clutch, switch off engine.
Do not use high pressure washer. Clean steering plate debris.
Raise hood, disconnect headlight wire, remove hood from tractor.
Check oil, lubricate, check bolts, battery, clean air screen, keep clean, check brake.
Check fuel, plug, connections, carburetor, fuel pipe for issues.
Check battery, contacts, lever position, fuse, ignition lock, safety contact, pedal.
Check gear, plug, carburetor, air filter, fuel tank vent, ignition, fuel pipe.
Check air filter, plug, carburetor, fuel pipe, carburetor settings.
Check engine overload, air inlet/cooling fins, fan, oil level, ignition, plug.
Check fuse, battery cells, battery pole/cable contacts.
Check bulbs, switch, cable short-circuit.
Check blades, engine mounting, blade balance for damage or sharpening issues.
Check blade sharpness, cutting unit skew, grass condition, grass under cover, tire pressure, gear, belt.
Clean machine, change oil, drain fuel, remove battery, store indoors, use degreaser for cleaning.
