PASCO SPARKlink PS-2009 - User Manual

®
Instruction Manual
012-10869A
*012-10869A*
SPARKlink
PS-2009
Introduction
SPARKlink is a sensor interface with two ports to accept
PASPORT sensors and a USB connection to a computer running
SPARKvue software. The built-in temperature and voltage probe
ports and included probes enable measurement right out of the
box with no additional sensors.
SPARKlink works with SPARKvue software running on you
computer to collect data for display and analysis.
Connecting SPARKlink to your
computer
1. Connect the included USB cable to the USB port on the back
of the SPARKlink.
2. Connect the other end of the USB cable to a USB port on
your computer.
3. Start SPARKvue. (If necessary, install SPARKvue on your
computer.)
Note: SPARKlink includes a port for external power, however it is not
necessary for operation because power is supplied from the computer
through the USB cable.
Connecting Sensors to
SPARKlink
Do one or more of the following to connect any sensors that you
would like to use:
• Connect one or two PASPORT sensors to the PASPORT
ports.
PASPORT
port
voltage
port
temperature
port
PASPORT
port
Included Equipment Replacement Part
SPARKlink PS-2009
Temperature Probe PS-2135
Voltage Probe PS-2165
USB Cable PS-2528

Summary

Introduction to SPARKlink

Connecting SPARKlink to Computer

USB Cable Connection Steps

Steps to connect the SPARKlink to a computer via USB cable and launch SPARKvue software.

Connecting Sensors to SPARKlink

Sensor Connection Procedures

Instructions for connecting PASPORT sensors, temperature probe, and voltage probe to the SPARKlink.

Technical Support and Product Information

PASCO Contact and Support Details

Contact information for PASCO scientific, including address, phone, fax, web, and email for assistance.

Product Legal and Compliance Information

Details on limited warranty, copyright, trademarks, and end-of-life disposal instructions.

PASCO SPARKlink PS-2009 Specifications

General

Model	PS-2009
Type	Data Logger
Digital Inputs	2
Resolution	12-bit
Connectivity	USB
Compatibility	Windows, iOS
Sampling Rate	Up to 1000 Hz
Power Source	USB