PAT America DS 350 Service Manual

PAT America DS 350

45 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

ww.patamerica.com

PAT America, Inc.

LOAD MOMENT INDICATOR

DS 350 MODULAR/GRAPHIC

for Lattice Boom Cranes

SERVICE MANUAL

P/N 031-300-190-118 REV. -, 12/18/2000

Table of Contents

Other manuals for PAT America DS 350

Operator's Manual54 pages

Questions and Answers:

S
smithnatalieAug 3, 2025
What to do if the PAT America Industrial Equipment shows error E04?
- K
  Kelly Brooks MDAug 3, 2025
  Error E04 can occur if the operating mode switch in the console is incorrectly set. Make sure to correctly set the operating mode switch to the code assigned to the crane's operating mode. Also, this error may appear if the operating mode isn't permissible with the current crane configuration, boom position, or area definition. Ensure the crane is set up according to proper operating configurations.
K
Kayla DawsonAug 11, 2025
What to do if PAT America Industrial Equipment boom position is out of the permissible working area?
- V
  Victoria AllenAug 11, 2025
  If the boom position is out of the permissible working area (over front), you should move the boom back to the permissible working area. Refer to the lifting diagram in the load capacity charts for guidance.
C
Carol NashAug 19, 2025
Why does my PAT America Industrial Equipment show error E01?
- C
  cindy93Aug 19, 2025
  Error E01 appears when the equipment falls below the minimum radius or exceeds the maximum angle specified in the load capacity chart, typically due to luffing the boom up too far. To resolve this, boom down to a radius or angle within the load capacity chart's specifications.

PAT America DS 350 Specifications

General

Brand	PAT America
Model	DS 350
Category	Touch Panel
Language	English