Patriot SolarGuard 155 User Manual

www.patriotglobal.com
electric fence energizer USER MANUAL
SolarGuard
TM
50, SolarGuard
TM
155
If you suspect the unit is not working then follow these steps:
1. Disconnect the unit from the fence and check the indicator light is
flashing.
2. Check the battery connection and voltage.
3. Check that the voltage between the live and ground terminals is
greater than 7000 V using a fence voltage tester.
4. If these tests are OK you have an installation problem.
Consult your user manual for installation and operating instructions
or contact Tru-Test Group Customer service on 800-874-8494.
STOP!
DO NOT RETURN
THIS PRODUCT
TO THE STORE

Patriot SolarGuard 155 Specifications

General

Battery Voltage	12V
Technology	PWM
Output Voltage	12V
Solar Panel Power	155W
Battery Type	Lead Acid

Summary

Key Symbols and First Use

Before First Use Procedures

Steps to follow before operating the unit for the first time, including battery connection and charging.

Installation and Connection

Positioning the Unit

Guidelines for placing the unit for optimal performance and safety.

Mounting the Unit

Instructions for mounting the unit onto various surfaces like posts or flat areas.

Connecting to Electric Fence

Steps for properly connecting the unit to the electric fence and grounding system.

Operation and Battery Management

Switching Unit On and Off

Battery Information and Replacement

Battery Charging Methods

Information on charging the battery using the solar panel or an external charger.

Battery Charger Requirements

Replacing the Battery

Safety and Hazard Information

General Safety Considerations

Important warnings regarding connections, operation, and compliance with regulations.

Safe Electric Fence Construction

Warning about the hazardous nature of electric fences and the risk of serious injury or death.

Specific Hazards and Precautions

Details on crossing fences, user supervision, prohibited electrifications, and spacing.

Fence Construction and Power Line Safety

Fence Construction Rules

Power Line Safety

Guidelines on clearances and height restrictions when installing near overhead power lines.

Troubleshooting Guide

Weak Shock or Flashing Light

Actions to take when the unit's shock is weak but the indicator light flashes.

Pulse Indicator Not Flashing

Steps to resolve issues where the pulse indicator light is not flashing.

Frequent Battery Replacement

Unit Appears Off / Standby Mode

Servicing and Warranty

Warranty Details

Product Specifications

Output Specifications