PATROLLINE HPS 845 E (H) - Operation with Default Remote Control; Alarm Arming Confirmation; Alarm Disarming Confirmation; Neutral Arming Status

2020
O
O
p
p
e
e
r
r
a
a
t
t
i
i
o
o
n
n
w
w
i
i
t
t
h
h
d
d
e
e
f
f
a
a
u
u
l
l
t
t
r
r
e
e
m
m
o
o
t
t
e
e
c
c
o
o
n
n
t
t
r
r
o
o
l
l
ALARM ARMING
Push closing button of default remote control of the vehicle. The arming will
be confirmed by the followings:
• Blinker flashing based on closing features of the vehicle
• 1 beep (if it is programmed)
• Switching ON of the LED on the dashboard
• Activation of electric engine immobilization (if it was connected)
• Activation of module outputs (optional ultrasonic sensors,
hyperfrequency etc.)
• The CDL closes the doors
ALARM DISARMING
Push opening button of default remote control of the vehicle. The disarming
will be confirmed by the followings:
• 2 beeps (if it is programmed)
• Switching OFF of the LED on the dashboard
• Deactivation of electric engine immobilizer (if it was connected)
• Deactivation of module outputs (optional ultrasonic sensors,
hyperfrequency etc.)
• The CDL opens the doors
• Blinker flashing based on opening features of the vehicle
N
N
e
e
u
u
t
t
r
r
a
a
l
l
t
t
i
i
m
m
e
e
,
,
a
a
r
r
m
m
e
e
d
d
s
s
t
t
a
a
t
t
u
u
s
s
After the alarm was armed with the default (OEM) remote control or with the PATROLLINE remote
control, the alarm will arm in the next 10 seconds, what signaled by the fixed light of the LED. During
this time, if each sensor will be tested, the alarm will sign it with blinker flashing (number of the blinker
flashing shows cause of the triggering, as table shows it in “Alarm memory” paragraph.)
The flashing of the LED on the dashboard will indicate that the system is ready to react with acoustic-
optic signal for triggering cause.