PAU Extra 300SP - Final Inspection and Pre-Flight; Pre-Flight Inspection Checklist

 Completed airframe
 Radio
 Throw templates or meter
 Set your throws accordingly. Double check to make sure all surfaces are moving in
the correct directions.
Chapter 9
Final Inspection and Pre-Flight
Welcome to the final chapter prior to your maiden flight! We hope you have enjoyed
building your Extra.
Let’s go over the airframe and perform a pre-flight to make sure everything is in order.
 Inspect the airframe for any visible damage and loose covering that may have
occurred during the build.
 Inspect the main landing gear and tail wheel assembly. Ensure all mounting
hardware and collars are fastened properly.
 Inspect your motor installation and cowl. Check the motor for possible contact with
cowl. Check propeller and spinner to ensure they are both secure.
 Inspect the inside of the fuselage to ensure your battery, receiver and wing bolts are
secured.
 Inspect all control surfaces and control surface hardware. Gently tug on each surface
to make sure the hinges are properly bonded.