PAU Extra 300SP - Page 5

 What you will need in this chapter for the main gear:
 Main gear
 One pair of wheels
 One pair of wheel pants
 One pair of wheel pant cuffs
 One pair of axles
 Two wheel collars
 Nylon spacers
 Fuselage
 Tail wheel assembly
 Slide wheel cuffs onto the main gear.
 Insert nylon spacer onto wheel axel, then wheel.
When putting collars on make sure the wheel can
rotate freely. We also recommend using lock-tite
on set screws to prevent collars from becoming
loose.
 Insert wheel axel onto main gear, on the back size use supplied washer and nut. Only
thread in the nut until wheel pant in slipped between the axel and main gear. Once
wheel pant is properly aligned tighten down nut while holding axel.
 Install landing gear on fuselage using the supplied 3mm screws and washers.
 With the main gear on, it is time to set the landing gear cuffs. First, cut a slit along the
neoprene tubing and slide the tubing onto the top edge of the gear cuffs, where the
cuffs will meet the fuselage.
 Next, take some Goop glue and apply it to the landing gear where the bottom of the
cuffs meet the gear.