through the horizontal stabilizer slot in the
fuselage. Once elevator is in you can now
install the horizontal stabilizer using thin CA.
Make sure horizontal stabilizer is properly
aligned before using any glue.
Next insert elevator onto the provided CA
hinges. Glue hinges using thin CA and carefully
dripping the glue on top of hinge on both sides.
Before gluing in the control horn, make sure to properly sand the portion that goes
into the wood. After sanding, test fit and glue with 5-15 minute epoxy. Make sure control
horn in completely in the surface.
Once glue has dried you can install the elevator servo and linkage.
Install the tail wheel with supplied screws.
To Next Page
Loading...