Pawleys Island Durawood Essentials User Manual

ASSEMBLY INSTRUCTIONS continue, back of page; Residential Lifetime Warranty, back of page
HARDWARE PACK
4 - 1" Barrel Bolt Assemblies
4 - 2" Flathead Screws
1 - Allen Wrench
1 - Square-Head Drill Bit
tabletop
TABLE PARTS
2 spreaders
4 legs
STEP 1. Set one Leg
on a at surface with
the groove near the
middle facing upward,
then t the tongue
piece at the end of
one Spreader into
the Leg groove (see
FIGURE 1 , at left, for
a close-up of tongue-
and-groove connection
points ). Fit another Leg
onto the top of that
Spreader in the same
manner, making sure
that the holes drilled at
one end of both Legs
are facing the same direction; Legs and Spreader will now form an
"H." (FIGURE 2).
NOTE: Chair parts are made to connect precisely, so you may nd
the t a little tight during assembly. If so, lightly tap parts into place
with a Rubber Mallet.
ASSEMBLY INSTRUCTIONS
HOLE
HOLE
SUGGESTED TOOLS (NOT PROVIDED)
• Rubber Mallet
• Standard Phillips Head Screwdriver
• Drill (Square-Head Drill Bit
provided in HARDWARE PACK)
USING BARREL BOLTS
EXTREMELY
IMPORTANT:
Use ONLY
a Standard
Phillips Head
Screwdriver to
tighten Barrel
Bolt Assem-
blies; do NOT
use a drill tted
with a Phillips
head bit, as
you can strip
the Barrel Bolt
head, marring
the appear-
ance of your
Durawood
Essentials
Side Table.
then
To correctly thread Barrel Bolts to Bolt Fasteners:
Fit the Fastener over the bottom of the Bolt, turn-
ing the Fastener at rst counterclockwise, until
you hear a slight click, which means the Bolt is in
its groove. Now begin tightening clockwise as you
normally would.
Congratulations on purchasing this Durawood Essentials Side Table! You’re going to love the quality, durability and simple assem-
bly — plus the full Residential Lifetime Warranty. QUESTIONS ABOUT THIS PRODUCT? Call our customer service team, (800) 643-3522.
Before beginning assembly, make sure you have all parts. Note
that not all parts pictured are to scale.
Durawood Essentials
Side Table
FIGURE 1
GROOVE
TONGUE

Pawleys Island Durawood Essentials Specifications

General

Brand	Pawleys Island
Model	Durawood Essentials
Category	Indoor Furnishing
Language	English

Summary

Product Components Overview

Table Parts

Lists the main components of the Durawood Essentials Side Table, including legs, spreaders, and tabletop.

Hardware Pack Contents

Details the hardware provided for assembly: barrel bolt assemblies, flathead screws, Allen wrench, and square-head drill bit.

Important Usage and Assembly Guidance

Barrel Bolt Tightening Warning

Crucial advice to use only a standard Phillips head screwdriver, not a drill, to avoid stripping barrel bolt heads.

How to Use Barrel Bolts

Step-by-step instructions on correctly threading barrel bolts into fasteners for secure assembly.

Suggested Tools for Assembly

Lists recommended tools not included with the product, such as a rubber mallet and specific screwdrivers.

Assembly Steps

Step 1: Connect Legs and Spreader

Connects one leg and one spreader, then another leg to form an 'H' shape, ensuring holes face the same direction.

Step 2: Secure Spreader and Repeat

Attaches the spreader to the leg using a flathead screw, then repeats the process for the other spreader and legs.

Step 3: Attach Tabletop

Slides the assembled leg/spreader 'H' pieces onto the tabletop's grooved corners, tapping lightly if needed.

Step 4: Insert Barrel Bolts

Inserts barrel bolts into tabletop holes opposite where legs connect, hand-tightening the fasteners.

Step 5: Tighten Barrel Bolts

Uses an Allen wrench and screwdriver to fully tighten the four barrel bolt assemblies, avoiding over-tightening.

Step 6: Final Placement

Sets the assembled Durawood Essentials Side Table upright, completing the assembly process.

Warranty Information

Residential Lifetime Warranty

Details the full lifetime warranty for residential customers covering defects like splintering or cracking.

Contractor 5-Year Warranty

Outlines the 5-year warranty provided for contractors purchasing the product.