Loose Leaf Quick Start
1. REMOVE THE LID
Remove the magnetic oven lid and pack with ground, loose-leaf material.
2. FIRMLY PACK YOUR OVEN.
PAX provides the best vapor when the oven is packed firmly— and at least
halfway full. Use multi-tool to firmly pack ground material inside of oven.
For a more eicient session with less material, use the half pack oven
lid. You can pack and fill the PAX device to the top edge of the oven for
a longer session. If you like, you can use the lid to firmly tamp down the
contents of the oven. Once your oven is nicely packed, replace the lid.
CAUTION: Please always make sure PAX 3 is not powered on or has been o for
at least 20 minutes before attempting to pack the oven.
3. TURN ON YOUR DEVICE.
A short press in the center of the mouthpiece will turn your device on.
PAX 3 heats in as little as 20 seconds, with PAX 2 in under 45 seconds.
The LED petals will pulse purple while heating.
4. GREEN MEANS GO.
Once the LED lights turn green, you’re good to go. A gentle, cigar-like
draw is best to start. Ensure your lips are placed around and not directly
in the opening of the mouthpiece. When drawing, PAX’s green lights will
pulse faster than usual.
*One full oven should last anywhere between 10 and 15 draws.
**A full battery charge should last approximately 10 sessions with PAX 3, and 5 sessions with PAX 2.
***Session and battery life are dependent on a number of factors including plant material and temperature settings.
To Next Page
Loading...
