Installation guide – Towel warmer
Pax Paulina, Elliot, Iris and Fredrik
Read this guide carefully before use.
We don’t take responsibility for printing errors and reserve the right to make changes to materials and designs.
According to the standard EN 60335, the following shall be considered. This appliance may be used by people aged 8 years up-
wards and by persons with reduced physical or mental capabilities or lack of experience and knowledge either under supervision
or provided they have been instructed on the use of the device in a safe manner and are aware of the risks. Children should not play
with the appliance. Children must not clean or maintain the appliance without adult supervision.
Thank you for choosing a Pax towel dryer
Pax Paulina, Elliot, Iris and Fredrik are electric towel warmers approved for installation in bathrooms and other damp
areas. They are intended for drying towels and similar textiles washed in water. To avoid danger for young children, the
warmer’s lowest horizontal bar must be placed at least 600 mm above the floor. The towel warmer reaches a temperature
of around 60°C, which can be hot to the touch.
Mounting
ATTENTION! On delivery, the connection box is prepared for concealed electrical connection and may only be installed by a qualified techni-
cian. The connection box must only be mounted with the circuit-breaker pointing downwards.
1. Remove the upper part of the connection box (A).
2. Use the lower part of the connection box as a (B) as a drilling template.
3. Choose a drill that is suitable for the wall type. Make sure you do not drill through electrical wires.
Seal the screw holes using silicon or other suitable sealing compound to prevent damp from penetrating into the
wall.
4. Put the cable from the wall through the bigger hole on part B. Then, attach part B on the wall.
5. Mount the other wall brackets on the wall, see figure 1-5 and then attach the towel warmer.
6. Mountscrew M6 (5A) on the three wall brackets with the Allen key to stabilize the towel warmer.
Electrical connection (230V AC 50Hz)
1. Connect phase, neutral and ground conductors in the terminal (D).
2. Assemble the rest of the parts to the connection box, C over B and A overlapping C.
3. Tighten the connection box screws.
Cleaning
The towel warmer can be wiped cleaned using a damp cloth with detergent. Do not use solvents.
EN
6
To Next Page
Loading...