2) Wi-Fi Settings
● Connection method:
In AP mode, the factory default IP address is 192.168.1.1
Open the browser to enter the default IP: 192.168.1.1 into the settings interface, the web
interface login password is 12345678.
Refer to WIFI Operation Manual.pdf for more details.
Note: the computer must be connected to the WiFi card to enter the page Setup.
● Printing the WIFI information:
1） Short press the power button for 3 times, then the printer starts printing the WIFI parameters
information.
2） Short press the power button for 5 times, then the printer will restore WIFI parameters
information (Restore to AP mode). The printer automatically restarts and the boot time is 2~3
seconds.
Fast flash
After exiting configuration mode, the
printing indicates that the WIFI
configuration
failed
and
the
LED
is
constant light.
Equipment connected or connected successfully means
it is in working status
Device disconnect or device connection unsuccessful
To Next Page
Loading...