For problems with installation or operation of the kit, please contact Paxton Access
technical support on:
Technical help is available: Monday - Friday from 07:00 - 01:00 (GMT)
Saturday from 09:00 - 13:00 (GMT)
Other documentation on proximity systems can be found on our web site - http://www.paxton.co.uk/
+44(0)845 8381716 support@paxton.co.uk
Silencing the reader
1. Take the silent operation card from the card box.
2. Present the card to the reader. The reader give a single beep.
3. The reader will now be silent when a token is presented.
4. To activate the beep again, present the silent operation card.
1 2 3 4
BEEP!
Silent operation card
Swipe this card to silence the
beeping noises made by the
reader. Swipe the card again
to re-enable the beeping
noises.
Silent operation card
Swipe this card to silence the
beeping noises made by the
reader. Swipe the card again
to re-enable the beeping
noises.
BEEP!
BEEP!
Swipe this card to bar:
Write name:
John Smith
Swipe this card to bar:
Write name:
John Smith
Swipe this card to bar:
Write name:
John Smith
Swipe this card to bar:
Write name:
John Smith
Swipe this card to bar:
Write name:
John Smith
Silent operation card
Swipe this card to silence the
beeping noises made by the
reader. Swipe the card again
to re-enable the beeping
noises.
Should it be required, the system can be reset. There are two ways of doing this. Only use one
method to reset the system.
1. Power down the unit
2. Press and hold the exit button (connect the exit button wires if no exit button is present.)
3. Power up the unit - wait for beep/red LED to go out
4. Release and press the exit button a further 2 times (within 3 seconds)
5. The reader will beep 6 times
6. WAIT FOR 5 SECONDS!
OR
1. Present Enrolment card
2. Present Door open time card twice
3. Present Enrolment card
4. Present Door open time card twice
5. WAIT FOR 5 SECONDS!
Reseting the system
To Previous Page
Loading...
Need help?
General
