Paxton Switch2 - Page 2

AN1069-US
Switch2
The KP reader must rst be initialised as a TOUCHLOCK keypad. (as above)
Next, put the keypad into 'Card plus code' mode by keying in the following sequence.
Card plus Code
A PROXIMITY card pack must now be enrolled by simply presenting the PROXIMITY enrolment card to the
reader. All of the cards in the pack will now be valid.
4 digit user codes are entered using the TOUCHLOCK programming chart. If more than one user code is to
be used, activate 'Multiple codes' before programming the user codes.
Entry will now be granted with the presentation of any valid card followed by any valid user code.
Card plus Code
2
1
Enter 6 digit Programming
Code
Hold down for 3 secs
2
Card or Code' mode is programmed in the same way as 'Card plus Code' except for using the following
program sequence to set up 'Card or Code'.
Card or Code
Entry now requires the presentation of a card or by entering a valid user code.
Card or Code
1
Enter 6 digit Programming
Code
Hold down for 3 secs
3