Paxton Switch2 - Page 3

AN1069-US
Switch2
3
Present the enrolment card to the keypad; the reader will start to beep and the
amber LED will ash
To assign a PIN to a card:
Present the user card, the amber and green LED's will ash
Enter the PIN number to be associated with the user card (Maximum 4 digits)
Press the bell button, the LED's will ash faster
Enter the PIN again to conrm
Press the bell button
The user card and related PIN are now valid. When the user card is presented at the keypad the amber LED
will light indicating that the keypad is waiting for the PIN. When the correct PIN is entered the door will open.
A User card must have a PIN assigned to be active.
The KP reader must rst be initialised as a TOUCHLOCK keypad.
Next, put the keypad into 'Card plus PIN' mode by keying in the following sequence.
Card plus PIN
Card plus PIN
1
Enter 6 digit Programming
Code
Hold down for 3 secs
1
A PROXIMITY card pack must now be enrolled by simply presenting the PROXIMITY enrolment card to the
reader.
Entry now requires the presentation of a valid card followed by its related user PIN.
4 digit PIN's are assigned as follows.