Forward Hatch Area
Picture at right showing typical
configuration and arrangement of gear.
(NOTE the factory prototype shown here
was built as normal and then modified to
hold a full-length pilot figure. You will
see that the upper portion of BH2 has be
removed to facilitate this installation and
is NOT part of the kit)
DV8R Nose gear
Service panel
made from
light ply and
supported on ½
x ¼ Spruce
Removable
Main air tank
on floor
behind BH2.
Receiver battery.
Steering control
Steering servo
ose Gear cut
out in balsa
ECU Battery
41
To Next Page
Loading...