Turbine Installation
The factory Prototype uses a JetCat P-80 (18 Pounds Thrust) located as shown. The
engine is mounted such that it is just above the 1/8
th
plywood joiner that ties the two
boom halves together. All turbine lines and pluming as well as the servo leads for the tail
are routed beside the motor mounts and up through the fuel tank area to the rear forward
hatch. No extensions were necessary for the turbine to be installed. For a complete list of
servos and extension materials see the “FAST FACTS” sheet supplied with this
instruction booklet.
Holes allow access to screws
for Turbine removal
Location of rear fuel cell
(Dubro 50) extends just
below rear NACA
o
enin
as shown here
All lines routed
forward through fuel
storage area
-
Rudder servos and
control rods
42
To Next Page
Loading...