Locate formers FF3, BH8 and TF1. Trial fit these parts together as shown below. Make
sure that all of the parts fit together squarely and tight.
correct and the boom
structure is square.
to
nt of former BH8 as
own at Right.
that
of the
odel as shown in photos).
e of the motor
ount as shown.
on a
e
squareness of the boom.
Once satisfied with the fit, add the
former FF6 and once again ensure th
the fit is
at
Now you can use a sanding block
square up the edges of the balsa
triangle at the fro
sh
Locate the motor mount assembly
corresponds to the boom you are
building. (The hardwood piece is
located away from the center
m
Using ½ balsa triangle, add pieces
to the rear and bas
m
Ensure that you are working
flat surface to maintain th
8
To Next Page
Loading...