Test the GFCI (or RCD)
May appear on a regular schedule, i.e. every 65 days.
The GFCI or RCD is an important safety device and must be tested on a regular basis to verify its reliability. Every user should be
trained to safely test the GFCI or RCD associated with the hot tub installaon. A GFCI or RCD (European) will have a TEST and
RESET buon on it that allows a user to verify proper funcon.
WARNING: If freezing condions exist, a GFCI or RCD should be reset immediately or spa damage could result. The end user
should always be trained to test and reset the GFCI or RCD on a regular basis.
Change the water
May appear on a regular schedule, i.e. every 90 days. Change the water in the spa on regular basis to maintain proper chemical
balance and sanitary condions.
Change the Filter
May appear on a regular schedule, i.e. every 30 days. Filters should be replaced regularly to maintain proper spa funcon and
sanitary condions.
Check Ozone
May appear on a regular schedule, i.e. every 365 days. Check your ozone/UV generator to assure properly sanized water.
Service Check
May appear on a regular schedule, i.e. every 365 days. Have a service tech do a check-up on your spa.
Warning! Qualified Technician Required for Service and Installaon
Do not aempt service of this control system. Contact your dealer or service organizaon for assistance.
Follow all owner’s manual power connecon instrucons. Installaon must be performed by a licensed electrician
and all grounding connecons must be properly installed.
To Previous Page
Loading...
Need help?
General