PDC spas Accent - User Manual

Navigaon
Navigang the enre menu structure is done with 2 or 3 buons on the control panel.
The Accent control panel has separate WARM (Up) and COOL (Down) temperature buons.
The MENU Buon is used to choose the various menus and navigate each secon.
The two Temperature buons (Warm and Cool) are used to select and change the parameter.
Typical use of the Temperature buons allows changing the Set Temperature while the numbers are ashing in the LCD.
The menus can be exited by pressing the Menu key repeatedly to return to main screen.
Waing a few seconds in the Main Menu will allow the display to revert to the Main Screen. Most changes are not saved
unless Menu/Select is pressed.
Sample Navigaon Flow
Power-up Screens
Each me the System powers up, a series of numbers is displayed.
Aer the startup sequence of numbers, the system will enter Priming Mode.
Eect. 6/2019
Accent™ Control Operaon Guide

PDC spas Accent Specifications

General

Brand	PDC spas
Model	Accent
Category	Controller
Language	English

Summary

Preparation and Filling

Priming Mode - M019

Initial mode for pump verification and water flow after power-up.

Priming the Pumps

Detailed steps to start and ensure pumps are primed.

Exiting Priming Mode

Temperature and Temp

Adjusting the Set Temperature

How to change the desired water temperature using control buttons.

Dual Temperature Ranges

Explanation of high and low temperature range settings and selection.

Mode, Ready and Rest

Different operational modes affecting heating and water circulation.

Show and Set Time of Day

Restricting

Adjusting

GFCI Test

Instructions and safety information for testing the GFCI.

General

Too Cold - Freeze Protection

How the system protects against freezing conditions by running pumps.

Water is too Hot (OHS) - M029

Indicates high water temperature and system shutdown for safety.

Heater-Related

Heater Flow is Reduced (HFL) - M016

Heater Flow is Reduced (LF)* - M017

Heater may be Dry (dr)* - M028

System Status and Errors

Heater Error Messages

Sensor Error Messages

Communications Error

System-Related Errors

Memory and Clock Errors

Configuration and GFCI Errors

Pump Stuck ON; Hot Fault

Indicates a pump is stuck ON, potentially causing overheating.

Maintenance Reminders and Warnings

Service and Installation Warning

Crucial warning about requiring professional service for installation and repairs.