To Next Page

To Previous Page

Preparaon and Filling

Fill the spa to its correct operang level. Be sure to open all valves and jets in the plumbing system before ﬁlling to allow as

much air as possible to escape from the plumbing and the control system during the ﬁlling process.

Aer turning the power on at the main power panel, the top-side panel will go through speciﬁc sequences. These sequences

are normal and display a variety of informaon regarding the conﬁguraon of the hot tub control.

Priming Mode – M019*

This mode will last for 4-5 minutes or you can manually exit the priming mode aer the pump has primed.

Regardless of whether the priming mode ends automacally or you manually exit the priming mode, the system will automa-

cally return to normal heang and ﬁltering at the end of the priming mode. During the priming mode, the heater is disabled to

allow the priming process to be completed without the possibility of energizing the heater under low-ow or no-ow condi-

ons. Nothing comes on automacally, but the pump can be energized by pushing the “Jet” buons.

Priming the Pumps

As soon as the above display appears on the panel, push the “Jet” buon once to start pump in low-speed and then again to

switch to high-speed. The pump will now be running in high-speed to facilitate priming. If the pump has not primed aer 2

minutes, and water is not owing from the jets in the spa, do not allow the pump to connue to run. Turn o the pump and

repeat the process. Note: Turning the power o and back on again will iniate a new pump priming session. Somemes mo-

mentarily turning the pump o and on will help it to prime. Do not do this more than 5 mes. If the pump will not prime, shut

o the power to the spa and call for service.

Important: A pump should not be allowed to run without priming for more than 2 minutes. Under NO circumstances should a

pump be allowed to run without priming beyond the end of the 4-5 minute priming mode. Doing so may cause damage to the

pump and cause the system to energize the heater and go into an overheat condion.

Exing Priming Mode

You can manually exit Priming Mode by pressing a “Temp” buon (Up or Down). Note that if you do not manually exit the

priming mode as described above, the priming mode will be automacally terminated aer 4-5 minutes. Be sure that the pump

has been primed by this me.

Once the system has exited Priming Mode, the top-side panel will momentarily display the set temperature but the display will

not show the temperature yet, as shown below. This is because the system requires approximately 1 minute of water owing

through the heater to determine the water temperature and display it.

Vitality Series Fitness Spas / LifeStyle Series Hot Tubs

Pump

Press the “Jets ” buon once to turn pump on or o, and to shi between low and high-speeds.

If le running, the pump will turn o aer a me-out period. The pump low-speed will me out aer 30 minutes. The high-speed

will me out aer 15 minutes.

If the spa is in Ready Mode, pump low may also acvate for at least 1 minute every 30 minutes to detect the spa temperature

(polling) and then to heat to the set temperature if needed. When the low-speed turns on automacally, it cannot be deacvated

from the panel, however the high speed may be started.

PDC spas Accent User Manual

Questions and Answers: