PDC spas Owner's Manual - SmartTouch Control Interface; Spa Screen and Pump Indicators; Value Adjustment and Screen Navigation

Operaon Systems, Luxury Series | SmartTouch™ Control
40
Luxury Spa Series—Spa Screen
The Spa Screen shows all available equipment* to control. The display shows icons that are related to the equipment installed on a
parcular spa model, so this screen may change depending on the installaon.
The icon buons are used to select and control individual devices.
Some devices, like pumps, may have more than one ON state, so the icon will change to reflect
the state of the equipment. Below are some examples of 2-speed Pump indicators.
Values Increment / Decrement and Invert
If an Up or Down buon is shown and pressed when on an eding page, and a value has been selected (highlighted), the value can
be incremented by pressing the up arrow or decremented by pressing the down arrow.
Common Buons
Exing Screens
The Back buon is on every screen except the Main Screen, the Priming Mode Screen are a Message Display
Screen.
When you see only this buon, or this buon plus an Inacve Save Buon, it means Back or Exit. It appears
on eding screens before you have changed any value, as well as on all other screens. When you see both the
Back buon and an Acve Save buon, the Save buon will Save, while the Back buon will Cancel. If the
screen mes out due to no acvity it will act like Cancel.
Page Right / Le
If there is a right arrow at the boom of the screen, it takes you to the next page.
If there is a le arrow at
the boom of the
screen, it takes you to the
previ-
ous page.
Jets Off Jets Low Jets High