PDC spas Owner's Manual - SmartTouch Control Advanced Settings; Restricting Control Access; Hold Mode and Set Temperature

Operaon Systems, Luxury Series | SmartTouch™ Control
39
Addional Sengs
Restricng
The control can be restricted to prevent unwanted use or temperature adjustments.
Locking the Panel prevents the controller from being used, but all automac funcons are sll acve.
Locking the Sengs allows Jets and other features to be used, but the Set Temperature and other programmed sengs cannot be
adjusted.
Sengs Lock allows access to a reduced selecon of menu items. These include Filter Cycles, Invert, Informaon and Fault Log.
They can be seen, but not changed or edited. To lock either Sengs or Panel first select Sengs (if it says “Unlocked”) or Panel (if it
says “Unlocked”), than press the word “Lock“ for at least 5 seconds. To unlock either Sengs or Panel first select Sengs (if it says
“Locked”) or Panel (if it says “Locked”), than press the word “Lock“ for at least 5 seconds. Press for 5 seconds to unlock.
Hold—M037*
Hold Mode is used to disable the pumps during service funcons like cleaning or r
eplacing the filter. Hold Mode will last for 1 hour unless the mode is exited manually.
If spa service will require more than an hour, it may be best to simply shut down power
to the spa. The Hold Icon on the Sengs Screen places the spa in Hold Mode and
displays the System Hold screen. Touch Back to exit Hold Mode.
Set Temperature
Press Up or Down once to display the Set Temperature (indicated by a flashing ºF or ºC, plus a change in color of the temperature).
Press Up or Down again to modify the Set Temperature. The Set Temperature changes immediately.
If you need to switch between High Temperature Range and Low Temperature Range you need to go to the Sengs Screen.
Press and Hold
If Up or Down is pressed and held, the temperature will connue to change unl you stop pressing, or unl the Temperature Range
limits are reached.
Press here for 5 seconds to lock or unlock
Panel locked and sengs unlocked
Set Temperature Up
Set Temperature Down