PDC spas Owner's Manual - SmartTouch Control Time and Filters; Time-of-Day and Filter Cycles

Operaon Systems, Luxury Series | SmartTouch™ Control
38
Time-of Day
Be sure to set the Time-of Day
Seng the me-of-day is important for determining filtraon mes and other background features. The Heat Icon on the
Sengs Screen takes you to a screen where you control the Time-of-Day.
On the Time-of-Day screen, simply select the Hours and Minutes. Use the Up and Down Buons to make changes, then Save. If no
me-of-day is set in the memory an Informaon Screen will appear. If you exit it and Informaon Icon will appear at the boom of
the Main Screen, unl the me-of-day has been set. NOTE: If power is interrupted to the system, Time-of-Day will be maintained
for several days.
Adjusng
Main Filtraon
Using the same adjustment as Seng the Time, Filter Cycles are set using a start me and a duraon. Each seng can be adjusted
in 15-minute increments. The panel calculates the end me and displays it automacally. The Filter Icon o n t h e S e  n g s
Screen takes you to a screen where you control the Filter Cycles.
Filter Cycle 2 - Oponal Filtraon
Filter Cycle 2 is OFF by default. Press “1” to view Filter 1. Press “2” once to view Filter 2. Press “2” again to turn Filter 2 ON or OFF.
When Filter Cycle 2 is ON, it can be adjusted in the same manner as Filter Cycle 1.
It is possible to overlap Filter Cycle 1 and Filter Cycle 2, which will shorten overall filtraon by the overlap amount.
The Meaning of Filter Cycles
1. The heang pump always runs during the filter cycle*
2. In Rest Mode, heang only occurs during the filter cycle
3. Purges happen at the start of each filter cycle
*For example, if your spa is set up for 24/hour circulaon except for shung off when the water temperature is 3˚F/1.3˚C above the
set temperature, that shutoff does not occur during filter cycles.
Main Filtraon
Viewing Filter 1 while Filter 2 is OFF
Viewing Filter 1 while Filter 2 is ON