PDC spas Owner's Manual - SmartTouch Control Utilities; Utilities Screen Options

Operaon Systems, Luxury Series | SmartTouch™ Control
42
Fault Log
The Fault Log is a record of the last 24 faults that can be reviewed by a service tech. Use the Up and Down buons to view each of
the Faults. When Priming Mode shows in the Fault Log, it is not a fault. Rather, it is used to keep track of spa restarts.
GFCI Test
The Ground Fault Circuit Interrupter (GFCI) or Residual Current Detector (RCD) is an important safety device and is required
equipment on a hot tub installaon.
CE registered systems do not have an RCD Test Feature due to the nature of the electrical service. The end-user must be trained
how to properly test and reset the RCD.
Reset Buon
Only use the Reset Buon prior to moving the spa to a new locaon.
Pressing the Reset the buon forces a new Test to be performed at the new locaon.
It is mandatory to verify proper installaon and funcon of the GFCI or RCD. Users /
owners are to manually test this safety device prior to each use. Should the device not
funcon properly, shut the hot tub off at the breaker and contact service tech.
Units Screen
The Units Icon on the Sengs Screen takes you to the Units Screen.
1. Press “Temp Display” to change the temperature between Fahrenheit and Celsius.
2. Press “Time Display“ to change the clock between 12 hr and 24 hr display.
Reminders
The Reminder Icon on the Sengs Screen takes you to the Reminders screen. Press
“Reminders“ to turn the reminder messages (like “Clean Filter”) ON (Yes) or OFF (No).
Clean-Up Cycle
Cleanup Cycle Duraon is not always enabled, so it may not appear. When it is available,
set the length of me Pump 1 will run aer each use. 0-4 hours are available. Sengs it to
0.0 Hr keeps the Cleanup Cycles from running.
The Cleanup Icon on the Sengs Screen takes you to the Cleanup Cycle screen.
Language
The Language Icon on the Sengs Screen takes you to the Language screen. Change
the language displayed on the panel.