PDC spas Owner's Manual - ProView Control Settings; Additional Settings: Reminders and Units; Panel Messages and Freeze Protection

Operaon Systems, Premium Series | ProView™ Control
50
Addional Sengs
Reminders
Helpful Maintenance messages that may appear periodically.
Hold: Used to display the pumps during service funcons like cleaning or replacing the filter. Hold mode will last for 1 hour unless
exited manually. If the spa service will require more than 1 hour, it is best to shot power off to spa.
Units: Specify me and temperature units.
Panels: Set how long it takes the panel to go to sleep aer the last acvity. Default is 30 minutes.
Turn on/off the panel lights.
Control the brightness of both the panel lights and the panel display together.
Cleanup: Cleanup Cycle Duraon is not always enabled, so it may not appear. When it is available, set the length of me Pump 1
will run aer each use. 0-4 hours are available.
Color: Pressing the Select Buon when Color is highlighted will cycle through 5 background colors available in the control.
Language: Select language.
Freeze Protecon
If the temperature sensors within the heater detect a low enough temperature, then the water devices automacally acvate to
provide freeze protecon. The water devices will run either connuously or periodically depending on condions.
GFCI Test
The Ground Fault Circuit Interrupter (GFCI) or Residual Current Detector (RCD) is an important safety device and is required
equipment on a hot tub installaon.
CE registered systems do not have an RCD Test Feature due to the nature of the electrical service. The end-user must be trained
how to properly test and reset the RCD.
It is mandatory to verify proper installaon and funcon of the GFCI or RCD. Users / owners are to manually test this safety
device prior to each use. Should the device not funcon properly, shut the hot tub off at the breaker and contact service tech.
Panel Messages
Most messages and alerts will appear at the boom of the normally used screens. Several alerts and messages may be displayed
in a sequence. Some messages can be reset from the panel. Messages that can be reset will appear with a “right arrow” at the
end of the message. This message can be selected by navigang to it at pressing the Select buon.
Possible freezing condion
A potenal freeze condion has been detected, or the Aux Freeze Switch has closed. All water devices are acvated. In some
cases, pumps may turn on and off and the heater may operate during Freeze Protecon. This is an operaonal message, not an
error indicaon.