PDC spas Owner's Manual - Water Chemistry Start-Up; Water Care Initial Start-Up

Operang System, LifeStyle Series | Accent™ Control
60
Miscellaneous Messages
Communicaons error
The control panel is not receiving communicaon from the System. Call for Service.
System-Related
Memory Failure—Checksum Error* – M022
At Power-Up, the system has failed the Program Checksum Test. This indicates a problem with the firmware (operaon program)
and requires a service call.
Memory Warning—Persistent Memory Reset (Persistent Memory Error)* – M021
Contact your dealer or service organizaon if this message appears on more than one power-up.
Memory Failure—Clock Error* – M020
Contact your dealer or service organizaon.
Configuraon Error (Spa will not Start Up)
Contact your dealer or service organizaon.
The GFCI Failure (System Could Not Test the GFCI) – M036
(North America Only) May indicate an unsafe installaon. Contact your dealer or service organizaon.
A Pump Appears to be Stuck ON – M034
Water may be overheated. POWER DOWN THE SPA. DO NOT ENTER THE WATER. Contact your dealer or service organizaon.
Hot Fault – M035
A Pump appears to have been Stuck ON when spa was last powered. POWER DOWN THE SPA. DO NOT ENTER THE WATER. Contact
your dealer or service organizaon.