PDC spas Owner's Manual - Water Chemistry Schedule; Water Care Schedule; Troubleshooting Water Issues

Operang System, LifeStyle Series | Accent™ Control
61
Reminder
General maintenance helps.
Reminder Messages can be suppressed by using the Preferences Menu (recommend service techs access only). Press a temp
buon to reset a displayed reminder message.
Clean the filter
May appear on a regular schedule, i.e. every 30 days. Clean the filter cartridge as instructed in the owner’s manual.
Test the GFCI (or RCD)
May appear on a regular schedule, i.e. every 30 days.
The GFCI or RCD is an important safety device and must be tested on a regular basis to verify its reliability. Every user should be
trained to safely test the GFCI or RCD associated with the hot tub installaon. A GFCI or RCD (European) will have a TEST and RESET
buon on it that allows a user to verify proper funcon.
WARNING: If freezing condions exist, a GFCI or RCD should be reset immediately or spa damage could result. The end user
should always be trained to test and reset the GFCI or RCD on a regular basis.
Change the water
May appear on a regular schedule, i.e. every 90 days. Change the water in the spa on regular basis to maintain proper chemical
balance and sanitary condions.
Change the Filter
May appear on a regular schedule, i.e. every 30 days. Filters should be replaced regularly to maintain proper spa funcon and
sanitary condions.