Thank you for purchasing the Game Stop wireless controller for the PLAYSTATION 3
video game system.
Contents:
1 AFTERGLOW PS3 WIRELESS CONTROLLER
1 USB Dongle (found attached to the controller)
1 USB Cable
1 Manual
Set up:
1) Remove the USB receiver that is attached to the bottom of the controller and plug it
into one of the free ports of your PLAYSTATION 3
2) USB receiver LED will flash rapidly while looking for positive connection with the
controller. USB receiver light will light up solid when the connection is established
3) Place the power switch is in “ON” position
4) Press the “HOME” button, the controller will be automatically assigned a player
number. (you can change the controller player number by pressing and holding the
HOME button and then changing the player number from the PS3 menu – refer to
your console manual for more information
5) The battery of the controller is low when its LED start flashing.
Power Save Mode:
Controller will go into Power Save Mode after 3 (three) minutes of inactivity. You need
to press the START button to turn it back to the ACTIVE mode
Important Notice
1. Recommended user age range 14+.
2. Adult supervision is necessary when controller is used by child
CAUTION:
Changes or modifications to this equipment not expressly approved by the manufacturer
could void the users authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the
To Next Page
Need help?
General