the change sensor put into leak or Aerated status(or use the tools wakeup
senor)this time receiver can use the new sensor ID, and inform the master,
master receive the confirm message and inform change ID success.
3.In the sensor when pairing, please make sure that only one sensor in pairing
mode.
4.A pairing is not successful, can be repeated for installing sensor tire inflation
or deflation.
5.The sensor in the paired, please were paired according to the left front, right
front, left rear, right after the order, to avoid wrong learning position sensor.
6. When the mobile terminal in learning to wait for mode, please will install
the corresponding tire sensor, inflated and deflated, at this point, the learning
success.
Sensor install
TPMS Modules Technical Parameters
To Next Page
Loading...
