Description
A Punching and binding lever
B Paperguide for paperformat when punching
C Punching slot
D Binding mechanism for comb opening
and closing
E Measuring gauge for determining comb size
F Waste container
G Slot for ring binder hole punching.
1
English
Guarantee and service:
The guarantee instructions and the service
addresses can be found in the enclosed
guarantee sheet.
• Press the binding lever A far enough back-
war
ds so that the binding comb is opened
wide enough for the paper to be comfortably
laid over it.
• Place the punched paper stack onto the
opened binding comb. Start with the front
cover. To close the binding comb, push the
binding lever A back to its starting position.
• Remove the bound document.
5. Insert the paper/film here to provide it with
4 ring binder holes.
6. Emptying the waste container
• The waste container F is situated on the
underside of the machine. Release the cover
of the waste container over a waste paper
bin and empty it. Close the waste container
again.
1. Setting up the machine
• Place the machine on a stable surface.
2. Punching and binding
• Lay the paper on the paperguide B.
3. Punching
T
est the punching result with a piece of scrap
paper before you punch the original docu-
ment.
• Tap the paper stack on a flat surface and
place it in the punching slot C with the pages
aligned to the left side.
• Press the punching lever A down to carry
out the punching procedure.
4. Binding
• Determining the binding comb size with
measuring gauge E.
• Place the plastic binding comb in the bin-
ding mechanism D with the side to be opened
uppermost.
How to use
• This machine has been developed for
punching paper and plastic sheets and for
binding these materials with plastic binding
combs. It must be used solely for this pur-
pose and inaccordance with these operating
instructions.
• Always make a test with scrap paper before
punching the original document.
• Empty the waste container regularly.
• Do not attempt to exceed the maximum
punching quantity of 8 sheets.
Safety precautions
To Next Page
Loading...
