58
The built-in webbing should face down on the front and rear of the corner
of the structure.
Please make sure the cover hangs at all four corners equally.
Please place the elastic part of the edge of the cover at the position of the
zipper door.
For the tying method of the Ratchet Strap, please refer to the video on the product webpage.
Reminder
Step 4.
Assemble the rest of the accessories.
a) Assemble the 4 x Ratchet Strap (#E) at the four corners and thread the built-in webbing
of the cover into the Ratchet Strap (#E), then hook the Ratchet Strap (#E) with the L-Shape
2 Corner Foot Base (#C).
b) Thread the 48 x Bungee Ball (#M) through the eyelet at the bottom of the cover and tie to
pole #7.
Step 3.
Put the Cover (#F) on the frame.
IMPORTANT
To Next Page