6. Connect the power cord from the transformer to a properly grounded, grounding type receptacle (GFCI).
7. If necessary, readjust the flow rate to the desired level (remember to always disconnect from the power source before handling the pump).
CARE & MAINTENANCE:
1. Keep the water clean – clean water will prolong the useful life of your pump.
2. Use a pre-filter on your pump if available.
3. Regular cleaning of the pump will be necessary depending upon the environment in which it is operated. Clean the pump when it is visibly soiled or
when a noticeable drop in performance is detected. Failure to clean the pump will result in overheating of the pump and the voiding of the
warranty!
4. Before cleaning, always disconnect the pump from the power source.
5. Disassemble the pump by removing the inlet screen & the impeller housing. Remove the impeller/rotor assembly by gently pulling on the impeller blades.
Use a soft cloth or brush to clean the area inside of the pump where the impeller/rotor assembly was. Clean the inlet screen, impeller housing & impeller
in warm soapy water. Reassemble the pump and inspect for proper operation.
HINTS & TROUBLESHOOTING:
1. Ensure that the pump’s flow control switch is set to maximum (+) before operating. Once the flow is established, the pump can be adjusted downward to
the desired level.
2. If the pump operates, but there is no flow, check to ensure the pump is fully submerged.
3. If the pump operates, but there is no flow, check the supply tubing for kinks and correct.
4. If the pump operates, but there is no flow, and if the pump is submerged and there are no kinks in the supply tubing, lift the pump from the water. Remove
supply tubing at pump outlet and clean tubing inside and out if necessary. Reset pump in water (outlet side up) and once water begins to flow, re-attach
the supply tubing.
IMPORTANT SAFETY INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY TO PERSONS
WARNING - Lighted lamp is HOT!
Lamp gets HOT quickly! Do not touch the lens, cover or enclosure.
Unplug and allow the lamp to cool before handling the lamp.
Keep lamp away from materials that may burn.
Do not touch the bulb at any time. Use a soft cloth. Oil from skin may damage lamp.
Do not operate the lamp with a missing or damaged lamp covers.
Do not remain in light if skin feels warm; Do not look directly at lighted lamp. Use only with a 10-watt or smaller bulb
Hot surface. Keep away from curtains and other combustible material.
Transformer is replaceable with model #TEAC-66-123500U. Bulb is replaceable with Type MR11 (12V 10W). Pump is replaceable
with model # HI-1000SP900. Call Customer Service for replacement parts.
SAVE THESE INSTRUCTIONS!
Each Peaktop product may have variations in texture, finish and appearance from one unit to the next. This enhances the beauty of the product and makes
your Peaktop product uniquely individual. Some products and finishes are intentionally weathered or worn in appearance for aesthetic design.
NOTE:
The diagrams shown are for illustrative purposes only.
Ref. # DE93598
Printed in China
Figure 1
Figure 2
To Previous Page
Loading...
