English 34 35 English
3. Charging starts automatically and takes approx.
2hours. Meanwhile LED lights red and goes out
when charging is complete.
• Low battery indicator: LED flashes.
Setting up Bluetooth connection
1. On/o switch in ON position. A signal sounds. LED
flashes rapidly. Speaker ready for connection.
2. Activate Bluetooth on audio source (e.g. mobile
phone). Browse for devices and select “PPA80BT”.
Establish connection. If necessary, enter password
0000
.
3. If necessary, select “PPA80BT” as audio output
device. LED lights up: connection established,
playback paused. LED flashes slowly:
connection
established, playback continued.
Wired connection
1. Connect Micro-USB plug to LINE/DC socket.
2. Connect jack plug to audio source’s headphone
socket.
3. On/o switch in ON position. A signal sounds. LED
remains on.
4. Start audio source playback.
Select playback mode
• Bluetooth takes priority over wired playback. To
switch to wired playback you must stop or pause
playback from the audio source.
1. Press and hold
button to switch between
Bluetooth and wired playback.
• Switching to Bluetooth takes approx. 5 seconds.
PPA80BT_62x62mm_131016 (1.5) (01 - DE EL EN ES).indb 35 16/10/13 5:01 PM
To Next Page
Loading...
Need help?
General
