Frequency Response: 68 Hz to 19 kHz, +/- 6 dB, anechoic environment
Usable Low Frequency limit (-10 dB point anechoic): 55 Hz
Nominal sensitivity (1W @1M, swept sine input in anechoic environment):
96 dB (average)
Maximum Sound Pressure Level (1 meter):
124 dB SPL peak with music
Radiation Angle measured at -6 dB point of polar response:
Nominal: 110 degrees horizontal X 80 degrees vertical
(Axis of the vertical main polar lobe is angled down 10 degrees, resulting in the angular pattern with respect to
straight ahead being +30, -50 degrees)
Transducer Complement:
Heavy-duty 12” woofer with 1 1/2” voice coil & 32 oz. magnet
DX™14 1.4” titanium diaphragm dynamic compression driver
Box Tuning Frequency: 52 Hz
Electroacoustic crossover frequency: 3,100 Hz
Crossover type:
Internal Electronic DSP based two-way crossover with driver EQ, level matching, bass boost, limiting and sub-
sonic ltering.
Crossover Slopes:
Linkwitz-Riley 24 dB/octave (4th order) low pass, 24dB/octave (4th order) high pass, both with driver EQ incor-
porated.
Input Connections:
One combo female XLR / 1/4" phone jack providing balanced line-level operation from the 1 / 4” jack section,
and the XLR section.
Output Connections:
One male XLR jack. e ru jack is intended for the use of linking multiple DM™112‘s in a line or to provide a
feed to a powered subwoofer, or other electronics that needs to receive a full range version of the input signal.
Enclosure Materials & Finish:
Black polypropylene plastic with textured surface, black powder-coated perforated full-coverage grille.
Mounting provisions:
Four rubber feet provide vibration free oor or stage use, and a molded-in stand mounting cup is on the bottom.
Unit is not designed to be own overhead
SPECIFICATIONS
To Next Page
Loading...