bars and an easy access, adjustable steel torsion rod. (See Adjustments–Torsion Rod for
adjustment instructions.)
Pickups
The two Peavey humbucking pickups supply optimal output and tonal response. A two
step wax dipping process is used to provide ultra low noise operation and resistance
to microphonic feedback. The pickups are mounted directly to the body, which further
reduces feedback at high volume levels and oers enhanced tonal response.
CONTROLS
Pickup Selector Switch (1)
This three-position switch
allows selection of pickups
in various combinations. The
selection possibilities are as
follows:
• Up = Neck pickup
• Center = Both pickups
• Down = Bridge pickup
Volume (2)
The volume knob controls the
total signal delivered from both
pickups. Rotating clockwise
will increase volume; rotating counterclockwise will reduce volume. Pulling the knob up
coil taps the bridge pickup.
Tone (3)
Rotating the tone knob clockwise will result in more treble (higher frequencies) and a
brighter tonality; rotating counter-clockwise will reduce the amount of treble. Pulling the
knob up coil taps the neck pickup.
Output Jack (4)
The output jack accepts standard guitar patch cords. (We recommend high-quality Peavey
XCON® patch cords.)
Adjustments
Your instrument has been carefully adjusted at the Peavey factory for accurate intonation
and playing ease. However, your playing style and requirements may necessitate additional
adjustments. These should be made by your authorized Peavey dealer; but with a little care
and by closely adhering to the following instructions, you may attempt these adjustments
yourself.
Note: Please read the instructions thoroughly before attempting any adjustments.
3
4
2
5
1
To Next Page
Loading...
Need help?
General
