Need help?Do you have a question about the Peavey Production Series and is the answer not in the manual?
General| Type | USB Microphone |
|---|---|
| Polar Pattern | Cardioid |
| Input Channels | 1 |
| Frequency Response | 20 Hz to 20 kHz |
| Sample Rate | 48 kHz |
| Bit Depth | 16-bit |
| Driver | Not Required (Class Compliant) |
| Compatibility | Windows |
Alerts user to uninsulated dangerous voltage within the product enclosure.
Alerts user to important operating and maintenance instructions in the literature.
Advises against opening the cover to reduce the risk of electric shock.
Information on selecting export power supply voltage and using the IEC power cord socket.
Recommendations for cable runs and grounding to minimize hum problems in a studio.
Lists essential tools required for servicing the console.
Selects LINE or TAPE source and between XLR mic or line input.
Provides +48V DC phantom power and engages a -20 dB pad for hot signals.
Reverses signal polarity and adjusts input gain for optimal performance.
Details the four EQ bands: HI/FREQ, HI MID/FREQ, LO MID/FREQ, LO/FREQ.
HPF attenuates low frequencies; EQ switch engages/disengages EQ circuitry.
Sets signal levels sent to the AUX A and AUX B buses.
Selects signal source for AUX sends from pre/post EQ or fader.
Sets signal levels sent to the AUX C and AUX D buses.
Sets signal levels sent to the EFX A, B, C, and D buses.
Controls stereo panning and provides signal status via LED.
Assigns channel output to various signal buses (L-R, 1-2, 3-4).
Assigns channel output to buses 5-24, covering all routing options.
Mutes or isolates channels for monitoring, with status LEDs.
Mutes/isolates channels, switches fader control between Aux/Effect sections.
Mutes signals or isolates channels, controls stereo panning for monitors.
Mutes signal or isolates channels for monitoring, with status LEDs.
Mutes signals or isolates channels for monitoring, with status LEDs.
Indicates signal status and provides Mute/Solo functions with LEDs.
Indicates signal status and provides Mute/Solo functions with LEDs.
Used for studio intercom/talkback or slating takes onto tape.
Turns oscillator On/Off and sets frequencies (40Hz, 1kHz, 100Hz, 10kHz).
Sets SOLO playback level and trims stereo bus gain to prevent overload.
Details source impedance, input impedance, nominal level, pad, S/N, and EIN.
Details input impedance and nominal input level.
Details input impedance, nominal and max signal input levels.
Details output impedance and nominal/max output levels.
Details HPF slope and EQ band types, ranges, and boost/cut.
Details indicator voltage levels and channel crosstalk performance.
Specifies frequency response and meter types/response.
Lists factors voiding warranty and procedures for obtaining service.
Lists OSHA-specified permissible noise level exposures based on duration.
Essential instructions for safe product use, including water, heat, and grounding precautions.
To Next Page
