Peavey Q 131 - Power Switch

POWER SWITCH (7)
Used to turn AC mains power on or off.
INPUT (8)
A
1/4"
Tip-Ring-Sleeve
(stereo)
jack
provides
balanced
inputs
when
used
with
stereo
(TRS)
1/4"
plugs
and
2-
conductor
shielded
cables.
When
used
with
a
mono
1/4"
phone
plug,
the
input
is
unbalanced.
OUTPUT (9)
A
1/4"
Tip-Ring-Sleeve
(stereo)
jack
provides
balanced
inputs
when
used
with
stereo
(TRS)
1/4"
plugs
and
2-
conductor
shielded
cables.
When
used
with
a
mono
1/4"
phone
plug,
the
output
is
unbalanced.
y
TITRE FITERE
erf
інін
НЫ
BLOCK DTAGRAM
This Block diagram snows
ae wie
in ПАСЕКА
no Block Sfogran careful y
oureut
METER
SPECIFICATIONS
‘Al specifications are typical unless otherwise noted.
04ВУ-1 Volt
All
specifications
are
referenced
to
nominal
output
level
(0
dBV)
unless
otherwise
stated.
All
measurements
are
wide
band
20
Hz
to
20
kHz
unless
otherwise.
stated.
NOTE: All specifications measured at 1 V RMS input and
unbalanced output. All sliders at mid position; all switches out
unless otherwise noted.
Frequency Response:
+1 dB 20 Hz to 20 kHz
Distortion:
003% 20 Hz to 20 kHz,
Input Impedance:
Balanced 20 K ohms (equal impedances to ground)
Output Impedance:
100 ohms
Maximum Input Level:
+18 dBV (8 VRMS)
Maximum Output Levelt
+18 JBV (8 VRMS)
Nominal Input Level:
0 dBV (1 VRMS)
Nominal Output Le:
0 dBV (1 VRMS)
Input Headroom:
Nominal 18 dB
Output Headroom:
18 dB
Output Noise:
EQ in bypass: -101 dBY
FQ in filter: -95 dBV
Filter Frequencies:
20, 25, 32, 40, 50, 63, 80, 100, 125, 160, 200, 250, 315, 400, 500,
630, 800, 1 K, 1.25 K, 1.6K, 2 K, 2.5 K, 3.15K, 4 K, 5 K, 6.3 K, 8
K, 10K, 12.5 K, 16 K, and 20 kHz
Filter Q:
477
Maximum Boost and Cut Filter:
DEER
Maximum Boost and Cut Gai
(Wide Band Gain)
+12 dB
Low Cut Filer:
40 Hz
Power Requirement:
Domestic: 120 VAC / 60 Hz / 20 W
Export: 230 VAC / 50/60 Hz / 20 W
Due to our efforts for constant improvement, features and specifica-
tions listed herein are subject to change without notice.