Need help?Do you have a question about the Peavey SP 4Ti and is the answer not in the manual?
General| Sensitivity | 99 dB |
|---|---|
| Impedance | 8 ohms |
| LF Driver | 15" woofer |
| Crossover Frequency | 1.8 kHz |
| Coverage Pattern | 90° x 40° |
| HF Driver | 1.4" titanium |
| Enclosure Material | Plywood |
| Type | 2-way full-range loudspeaker |
| Power Handling | 400 Watts RMS, 1600 Watts Peak |
Specifies the operating frequency range from 48 Hz to 17 kHz, with a low frequency limit at 48 Hz (-3 dB).
Details continuous power handling at 350 watts RMS and program power handling at 700 watts.
Indicates output levels: 102 dB SPL at 1W/1m and a maximum of 127 dB.
Lists the drivers: two 15-inch Kevlar impregnated woofers and a titanium compression driver on a horn.
States the nominal impedance as 4.0 ohms and the minimum impedance as 3.9 ohms.
Provides the physical size of the enclosure: 26" W x 53" H x 20" D.
Details the SP 4Ti as a full-range, quasi-three-way speaker system with a trapezoidal enclosure for sound reinforcement.
Explains the frequency response measurement at 1 meter with a 2.82V swept sine input, confirming 48 Hz to 17 kHz.
Describes the power handling rating methodology using pink noise with peaks, ensuring system durability for high-tech music.
Explains beamwidth and directivity factors derived from -6 dB points, providing insight for enclosure placement.
Illustrates horizontal and vertical polar patterns at various frequencies (500 Hz to 16 kHz) showing coverage.
Shows connection options for Normal (Full Range) and Bi-Amp (HI/LOW) modes.
Summarizes key specs: 48 Hz-17 KHz bandwidth, 102 dB output at 1W/1m, 4 ohm impedance, 350W continuous power.
Provides details on obtaining warranty statement copies from Peavey Electronics Corporation.
To Next Page
