Peavey V4X - Page 5

SP-2*
Crossover Frequency
E35
Reale НЕЕО
Nat Uses
eee
®
e
e
==
тиз | peer
оф ames
‘TWO-WAY SYSTEM CONNECTION
The hookup procedure for the SP-2 is illustrated.
(Crossover
frequencies
will
be
different
for
otherappli-
cations.) The majority of two-way systems will require
use of the Mid and High frequency outputs rather than
the Low and Mid.
Use XLR balanced outputs for long cable runs.
MFI”
MB-2"
FH*1
ETT
EJA
Acsate HE EO.
es © è
PROJECT" TWO
THREE-WAY SYSTEM
CONNECTION
Project" Twoillustrated, hock-
up is typical for most three-way
systems. (Crossover frequencies
will be different for other appli-
cations.) % inch output jacks
may be used as illustrated when
VAX * and power amps are in the
sama rack
For long cable runs, use XLR
balanced outputs,
3020HT*
415 Sub”
18
Crossover Frequencies
лоне
actuate
AO
е
E x
©
e
È
De Not Activate
HEEG
]
М
зонт" CROSSOVER
A
FOUR-WAY SYSTEM
CONNECTION
415 Sub апа 3020HT illus-
trated, hookupistypical for most
four-way systems. (Crossover fre-
quencies will be different for
other applications.) % inch out-
put jacks may be used as illus-
trated when V4X* and power
To 115 Sub" Input
amps are in the same rack.
For long cable runs, use XLR
balanced outputs.
(€
A AA