Need help?Do you have a question about the Peavey Vintage and is the answer not in the manual?
General| Reverb | Yes |
|---|---|
| Effects Loop | Yes |
| Type | Tube Amplifier |
| Power Output | 50 Watts |
| Channels | 2 |
| Footswitch | Optional |
Explains the function of normal and bright channel input jacks for tonal range and high-frequency emphasis.
Details the function of volume, bass, middle, and treble controls for gain, tonal balance, and response shaping.
Describes the reverb control for sustain and clarity and the master volume for overdrive and noise control.
Explains the pilot light, standby switch for tube filament warm-up, and the main on/off switch.
Covers fuse replacement, ground switch for hum reduction, and 3-wire line cable for safety.
Details the main speaker output jack #1 (switching) and external speaker jack #2 functionality.
Emphasizes never operating the amplifier without a speaker load to prevent internal damage and arcing.
Provides instructions on handling 6L6GC output tubes, including care with index pins to avoid damage.
Explains the reverb footswitch jack for remote reverb cut off using a standard footswitch.
Details the output power at 1 KHz, rated load, and power vs. distortion across different load impedances.
Provides specifications for peak output current/voltage and music power output ratings.
Lists sensitivity and input impedance for the amplifier's input stage.
Specifies distortion levels at 1 KHz and the frequency response range of the amplifier.
Details the range of tone controls, including bass, middle cut, and treble adjustments.
Describes the continuously variable reverb control and the master volume's role in producing overdrive.
To Next Page