PEDROLLO DG PED 5 - User Manual

Questions and Answers

A
Andrew ElliottJul 25, 2025
What to do if PEDROLLO DG PED 5 Industrial Equipment shows a DRY RUNNING alarm?
- C
  christopherwilsonJul 25, 2025
  If you're experiencing a DRY RUNNING alarm with your PEDROLLO Industrial Equipment, indicated by a flashing Red LED and Green LEDs in position 1, check for the presence of water in the aspiration line and ensure it's not blocked. You may need to fill and prime the pump.
S
Stacey VaughnAug 1, 2025
What to do if PEDROLLO Industrial Equipment shows an alarm of SHORT CIRCUIT?
- C
  Craig MoranAug 1, 2025
  If your PEDROLLO Industrial Equipment displays a SHORT CIRCUIT alarm (Red LED flashing, Green LEDs in position 1 fixed), first, check if the pump is blocked by opening the motor's posterior tap and rotating the shaft. Also, verify the cable, plug, and socket are intact and free from dispersions.
Z
zwoodsAug 7, 2025
What to do if PEDROLLO DG PED 5 Industrial Equipment pump does not switch on?
- D
  douglashannahAug 7, 2025
  If the PEDROLLO Industrial Equipment pump doesn't switch on when supply is needed, several LED indicators offer clues: * If the Red LED is permanently on, switch the pump on using the “I/O” switch. * If the Red LED is flashing, refer to the list of alarms in the previous pages. * If the Green LED is permanently on, the system pressure isn't dropping below the set working pressure.
B
Brenda BurkeAug 13, 2025
Why PEDROLLO Industrial Equipment shows alarm of ELECTRIC POWER too low?
- T
  Tricia HowardAug 13, 2025
  If your PEDROLLO Industrial Equipment is alarming due to ELECTRIC POWER being too low, indicated by a flashing Red LED and Green LEDs in position 5, it means the voltage is more than 15% below the set value. Stabilize the voltage to keep it within the +/-15% limits.
C
cynthia06Aug 18, 2025
How to fix PEDROLLO Industrial Equipment keyboard that does not switch on?
- D
  Debra JohnsonAug 18, 2025
  If the keyboard on your PEDROLLO Industrial Equipment doesn't switch on, verify that the lateral switch is in the “I” position. Also, ensure the electric current is switched on and the differential switch is suitable.