What to do if PEERLESS Water Dispenser softener fails to regenerate?
If your PEERLESS Water Dispenser softener isn't regenerating, several issues could be the cause. First, make sure the unit has consistent electrical service by checking the fuse, plug, pull chain, or switch. If the power supply is fine, the timer might be defective and need replacement. Also, check if there was a power failure, and if so, reset the time of day.
General| Brand | PEERLESS |
|---|---|
| Model | CME Series |
| Category | Water Dispenser |
| Language | English |
Introduction to the CME Series water softeners and their purpose.
Technical drawing and detailed specifications for the 30 CME model water softener.
Visual representation of the water softener's installation layout and required dimensions.
Specific instructions, tubing guidelines, and safety warnings for installation.
Step-by-step guide for initial setup and operation of the water softener.
Installer settings, user displays, and control valve programming instructions.
Details automatic/manual regeneration, and system sanitization procedures.
Procedure for setting the current time on the control unit, especially after power loss.
Explanation of the bypass valve functions and its four operational positions.
Instructions for removing, servicing, and reassembling the drive assembly of the control valve.
Procedures for servicing drive cap, pistons, spacer stack, and refill flow control.
Guidance on servicing the water meter and bypass valve components.
Common problems with the water softener, their causes, and recommended solutions.
Solutions for issues related to the control unit's display, programming, and error codes.
To Next Page