8
BASSINET, MAKE SURE THAT EVERY PART
IS PROPERLY AND SECURELY IN PLACE.
• ASSEMBLY AND PREPARATION OF THE
ITEM MUST BE CARRIED OUT BY ADULTS.
• DO NOT USE THE PRODUCT IF THERE
ARE MISSING OR BROKEN PARTS.
• BEFORE USE MAKE SURE THAT ALL OF
THE ATTACHMENT MECHANISMS ARE
CONNECTED PROPERLY.
• DO NOT INSERT FINGERS INTO THE
MECHANISMS.
• IT COULD BE DANGEROUS TO USE
ACCESSORIES WHICH ARE NOT
APPROVED BY THE MANUFACTURER.
• DO NOT USE THE NAVETTA XL
WITHOUT ITS FABRIC COVERING,
WHICH CANNOT BE REPLACED
WITH ONE NOT APPROVED BY THE
MANUFACTURER.
• TAKE CARE WHEN ADJUSTING THE
MECHANISMS (HANDLE, BACKREST)
WITH THE CHILD IN THE PRODUCT.
• IF A SHEET IS USED, CHECK THAT
DIMENSIONS FIT THE DIMENSIONS OF
THIS BASSINET.
• STRINGS CAN CAUSE STRANGULATION!
DO NOT PLACE ITEMS WITH A STRING
AROUND A CHILD’S NECK, SUCH AS
HOOD STRINGS OR PACIFIER CORDS.
DO NOT SUSPEND STRINGS OVER A
BASSINET OR CRADLE OR ATTACH
STRINGS TO TOYS.
• DO NOT PLACE THIS BASSINET NEAR A
WINDOW OR A PATIO DOOR WHERE A
CHILD COULD REACH THE CORD OF A
BLIND OR CURTAIN AND BE STRANGLED.
NOTICE
THIS ARTICLE MEETS OR EXCEEDS ALL
REQUIREMENTS COVERED IN ASTM F
2194 STANDARD AND LATEST REVISIONS.
instructions for use
using the Navetta XL
1• HOOD: To attach the hood, fasten the clips (fig_a)
and then the buttons on the sides (fig_b) and, if
present, the back (fig_c).
2• There is a special section in the hood that allows
you to see the child from any angle.
3• COVER: Put the cover in place and button it on
both sides.
4• It is possible to attach the cover to the hood, thus
providing the child with greater protection from
the elements. Unfasten the cover at the sides
To Next Page
Loading...
Need help?
General
