9
(arrow_a), fold it up (arrow_b) and fasten it to the
hood with the Velcro (arrow_c).
5•
HANDLE: Rotate the handle upwards until it clicks
into place (arrow_a). The handle is only locked in
place when it is in the vertical position. To lower the
handle, press the two round buttons at the same
time (arrow_b) and rotate it downwards (arrow_c).
The handle is useful for carrying the Navetta XL
(fig_d) and for fitting it to chassis and strollers.
6• ROCKING POSITION: The base of the Navetta XL
has a special shape which allows you to rock the
child when it is placed on a flat surface.
7• COT POSITION: It is possible to make the Navetta XL
into a non-rocking cot by opening out the two legs
under the base.
8• ADJUSTING THE BACKREST and THE FOOTREST:
with the COMFORT SYSTEM, backrest and footrest
can be adjusted simultaneously. Pull the knob
outwards (fig_a) while turning it (fig_b) to raise or
lower the backrest and the footrest.
9• FOUR SEASONS SYSTEM: There are holes under
the base of the Navetta XL which can be opened
or closed to adjust the air circulation inside it.
To open the holes, move the 4 levers outwards.
ganciomatic system
10• Ganciomatic is the quick, practical system that
allows you to attach the Navetta XL to the chassis.
To attach the Navetta XL, put it on the chassis and
press with both hands until it clicks into place.
Always apply the brakes on the chassis before
attaching and removing the Navetta XL.
Check that the bassinet unit is properly attached.
•
To release it, raise the lever of the Ganciomatic clip
(arrow_a) and lift up the Navetta XL (arrow_b).
removing the lining
11• REMOVING THE LINING OF THE NAVETTA XL:
Unbutton the hood on the sides and the back
(fig_a), press down on the clips to release them
(fig_b) and pull the hood upwards to remove it.
12• Unbutton the cover and remove it (fig_a), raise
the backrest, detach the inner lining (fig_b) and
pull it upwards to remove it (fig_c).
padding cleaning instructions
• Brush the fabric parts to remove dust and hand
wash at a maximum temperature of 30° without
wringing.
• Do not use chlorine bleach.
• Do not iron.
• Do not dry clean.
• Do not remove stains with solvents and do not
tumble dry.
product cleaning
• This product requires a small amount of
maintenance. Cleaning and maintenance must only
be carried out by adults.
• Keep all moving parts clean and if necessary
lubricate them with light oil.
• Clean the plastic parts periodically with a damp
cloth. Do not use solvents or similar substances.
• Brush the fabric parts to remove dust.
To Next Page
Loading...
Need help?
General
