25
seats of car models specified in the list
attached to these instructions.
• The car seat can only be used in
approved cars, fitted with a 3-point
static seat belt or winder, approved in
accordance with standard UN/ECE R16
or equivalent regulations.
• IMPORTANT: the use of a 2-point seat
belt or lap belt is forbidden.
WARNING
• Carefully read the instructions
before use and keep them in a safe
place for future reference. Failure
to closely follow the car seat
installation instructions will put
your child at risk.
• Viaggio 2-3 Flex must be assembled
and installed by adults, keeping
children away from the product.
• When travelling in the vehicle, never
hold your child in your arms or allow
him/her to sit outside of the car seat.
In the event of sudden braking, even
at low speeds, the child might easily be
flung forward.
• Do not insert fingers into the
mechanisms.
• Pay particular attention to luggage
or other objects that could injure the
child sitting in the car seat in case of
an accident.
• Do not use installation methods other
than those recommended because
they could cause the seat to detach.
• Ensure the vehicle's 3-point seat belt
used to fix the car seat to the car is
appropriately tensioned and untwisted.
• Never leave your child unattended in
the car seat: watch him even when he
is sleeping.
• Never remove your child from the seat
when the vehicle is moving.
• Check that the car seat is not blocked
by a moving part of the seat or a door.
• Adjust the height and tension of the
belts, checking that they adhere to the
child’s body without being too tight.
Check that the seat belt is not twisted
and the child cannot unfasten it.
• Do not leave the car seat in the vehicle
under the sun; if necessary, fold the
backrest (fig. 41) so as to protect the
seat from direct sunlight.
• Do not use the car seat without
the lining. This lining cannot be
replaced by other lining that has not
been specifically approved by the
manufacturer because it is an integral
part of the seat and is essential for
safety purposes.
• Do not remove or replace the white
polystyrene parts under the headrest or
under the side protection wings as they
are essential for safety purposes.
• If in doubt, contact the manufacturer
or retailer of this car seat.
• This article's serial number may be
found on the approval label situated on
the rear of the backrest (fig. 45).
• Do not remove the adhesive and sewn
labels. Removal of these labels could
result in the product not complying
with the law.
• Do not use the car seat if it is broken or
if there are missing parts, if it is second-
hand, or if it has been subjected to
heavy impacts as a result of accidents,
as it may present hidden yet dangerous
structural damage.
To Next Page
Loading...
