PEL 2009 - Leveling the Appliance; Personal Safety During Installation

INSTALLATION
1. Remove packing carton and all thermopore pieces from the
refrigerator, specially one at the back of the compressor.
Install the Appliance on a firm, flat surface or a Wooden
Pedestal (Chowki).
2. For optimum performance install the refrigerator in a well ventilated
place. Avoid installing the refrigerator near heat generating home
appliances such as heater, stove and in small nooks / corners, direct
sun light.
Leveling the Appliance
3.
To compensate any floor unevenness, adjust the balance of Appliance
by rotating the Leveling Screws clock wise or anti clock wise.
4. Always install your refrigerator in a tilted position as shown.
For personal safety, properly ground this Appliance.
5.
Do not ground the refrigerator with a telephone line, gas pipe, etc. It is
necessary that refrigerator should be connected to the proper earth point.
04
The manufacturer will not be responsible for any loss or damage if
precaution in this regard is not observed.
IMPORTANT:
NOTE:
Retain the original packing in case you need to ship it at a later date.
above 12”
ab
e 4”ov
a
p
r
o
x.
1/
3
p
”