To Next PageTo Next Page
Need help?Do you have a question about the Pelco KBD300A and is the answer not in the manual?
Program and operate the CM6700 Matrix Switcher/Controller Unit (SCU).
Program and operate the CM6800 Matrix Switcher/Controller Unit (SCU).
Control up to 16 receivers connected directly to the keyboard.
Supports CM6700 matrix auxiliary commands and relays.
Supports CM6800 GPI commands and relays.
Similar to Direct P Protocol, uses same commands in Direct D.
Connects a single keyboard to the LOCAL KEYBOARD port within 25 feet.
Connects multiple keyboards using KBDKIT/KBDKIT-X to the REMOTE KEYBOARD(S) port.
Connects direct-powered keyboards to COM 5/6 (CM6800-48X8) or COM 5 (CM6800-32X6).
Connects remote keyboards using KBDKIT/KBDKIT-X to CM6800 COM 5, 6, 7, or 8.
Installs an ASCII keyboard using an RS-232 connection with a converter.
Installs an ASCII keyboard using an RS-422 connection.
Installs an ASCII keyboard using an RS-232 connection and converter.
Installs an ASCII keyboard using an RS-485 connection.
Connects the keyboard directly to a maximum of 16 receivers using Pelco P or D Protocol.
Sets unique addresses for each keyboard using switches 1-4.
Configures keyboard operational modes using switches 5, 7, and 8.
Selects the monitor number for operation.
Selects the camera to view, potentially restricted by system settings.
Controls camera movement and zoom speed using the joystick.
Adjusts focus and iris using dedicated lens control keys.
Sets, programs, and recalls camera preset positions.
Programs and operates camera movement patterns (auto, random, frame, preset).
Steps through cameras sequentially, displaying status and time.
Starts a group camera sequence for macro programming.
Controls display of multiple camera images on the monitor using F1-F3 keys.
Controls built-in or external auxiliaries and relays.
Acknowledges alarms or halts pattern programming.
Provides information on handling alarms.
Enters programming mode for CM6700/CM6800 switchers.
Indicates monitor, camera, receiver number, or program mode.
Shows firmware version on power up (for versions prior to 4.0).
Cancels entered numbers or erases numerical entries.
Applies to specific Spectra models for IR cut filter control.
Enables the keyboard to send multiplexer commands.
Moves camera back and forth between stops automatically.
Moves camera in a random pattern.
Moves camera in 10-degree steps.
Sequences camera through all programmed presets.
Details the terms and exceptions of Pelco's product warranty.
Provides instructions for returning merchandise for repair or credit.
General