Pelco Manual C527M-L (3/04) [ 31 ]
Table F. Operating Scan Functions with Various Receivers
Function
Receiver Controlling Auto Random Frame
Preset
Stop
Model Protocol Scan Scan Scan Scan
All
15-bit 97 97
96
Pelco
(standard) Preset Preset N/A (2)
Preset
Coaxitron
®
(1) (3) (1)
98 Preset
IRD2024 Extended or 97
N/A N/A
96
ERD2200 Coaxitron 99 Preset Preset Preset
(3)
All Spectra
Ext. Coax.,
99 97 98
96
All Esprit
Serial Pelco
Preset Preset Preset
N/A Preset
P or D or PTZ
LRD41C Ext. Coax., 99 99
96
(before Serial Pelco Preset Preset N/A N/A
Preset
ver. 2.98) P or D (1) (3) (1)
LRD41C Ext. Coax., 99
97 96
(ver 2.98 Serial Pelco Preset
Preset
N/A N/A
Preset
and later) P or D (3)
ERD97P21-U Serial Pelco P N/A 97 Preset 98 Preset N/A 96 Preset
(1) First entry starts random scan, next entry changes to auto scan, etc.
(2) Enter dwell time (5-64 sec.) and press IRIS CLOSE.
(3) Changes to random scan after 30 minutes.
Scanning Functions
Operation of the scanning functions depends on the kind of receiver or pan/tilt mechanism you have and
the operating mode of your keyboard (CM6700, CM6800, or Direct Mode).
There are four types of scanning functions: auto (moves camera back and forth between stops), random
(moves camera in a random pattern), frame (moves camera back and forth in 10 degree steps), and preset (se-
quences camera through all programmed presets, pausing between each).
Operate scans according to Table F.
To Next Page
Loading...
