17
EMPTYING THE STEAM GENERATOR TANK
(ONLY FOR MODEL WITH STEAM GENERATOR)
287730
Before transporting a dryer that has been previously used, the
steam generator tank must also be emptied. Otherwise, water
from the tank may spill into the dryer interior. Move the dryer
approximately 40 cm away from the wall and tilt it backwards.
1
The steam
generator tank
emptying plug is
located on the front
side (lower right
hand side).
2
Place an empty
vessel under the
plug (approximately
2 l) and pull out the
plug.
3
When the water
is discharged,
replace the plug
(if the plug is not
replaced, water will
spill from the dryer
during the next
drying cycle).
To Next Page